Step It UP! Saturday

I used:
Stamps: Just Believe #120453 clear, #116948 wood
Paper: Patterns Designer Series Paper Stack-Brights #117155, Old Olive CS #100702, Rich Razzleberry CS #115316, Basic Black CS #121045, Whisper White CS #100730
Ink: Old Olive Marker #100079, Rich Razzleberry Marker #120970
Other: 5/8" Satin Ribbon Old Olive #117292, Uni-ball Signo Gel Pen #105021, Crop-a-dile #108362, Dimentionals #104430


I had a request to show how I did the ribbon for the step 2 card. I didn't show it on the video because I try to keep the videos at or below 10 minutes AND the punch I use is a retired product. I took a few pictures showing what I use and an alternative if you don't already own this particular punch. I hope this is helpful.

This is the step 2 card partially assembled

This punch makes two little holes 1/4" apart. It makes it easy for adding a little bit of ribbon.

I usually turn my punches over to see exactly where my holes will go.

You can also use the small hole punch on a crop-a-dile to get the exact same hole size. You will just need to measure the distance between the two holes.

I will often mark the card using the SU hole punch, but if the card has 3 layers it is difficult to punch through with the punch, so I use the marks and punch with my crop-a-dile.

Put the ribbon through the holes and tie a simple knot.

I usually pop this part of the card up a little by using dimentionsals.

Thanks for stopping by and looking :-)